Author |
|
Holger Newbie
Joined: 24 May 2013 Location: Germany
Online Status: Offline Posts: 1
|
Posted: 24 May 2013 at 3:05am | IP Logged
|
|
|
After intallation, the ports, input mail (143) and outgoing mail (25) are registered. Can not send the mail. Also the change of ports on SSL, input messages (993) and output messages (465), did not change. The log showed no port changes.
"Connecting to server 127.0.0.1 on port 25"
regards
Holger
|
Back to Top |
|
|
Igor AfterLogic Support
Joined: 24 June 2008 Location: United States
Online Status: Offline Posts: 6103
|
Posted: 24 May 2013 at 3:29am | IP Logged
|
|
|
Can you confirm both WebMail and mail server run on the same machine?
--
Regards,
Igor, AfterLogic Support
|
Back to Top |
|
|
bbsemail Newbie
Joined: 24 August 2010 Location: United States
Online Status: Offline Posts: 3
|
Posted: 02 June 2013 at 4:14pm | IP Logged
|
|
|
I'm having the same problem. Don't know if I should start a new thread or post here. I'm using POP3 on port 110 and SMTP on port 25. Sending should use the same authentication as receiving. I made several edits in settings.xml, but can't send. Here's the relevant content from settings.xml
<AllowWebMail>On</AllowWebMail>
<IncomingMailProtocol>0</IncomingMailProtocol>
<IncomingMailServer>thenetpros.net</IncomingMailServer>
<IncomingMailPort>110</IncomingMailPort>
<IncomingMailUseSSL>Off</IncomingMailUseSSL>
<OutgoingMailServer>thenetpros.net</OutgoingMailServer>
<OutgoingMailPort>25</OutgoingMailPort>
<OutgoingMailAuth>AuthCurrentUser</OutgoingMailAuth>
<OutgoingMailLogin>brad@thenetpros.net</OutgoingMailLogin>
<OutgoingMailPassword>?????</OutgoingMailPassword>
<OutgoingMailUseSSL>Off</OutgoingMailUseSSL>
<OutgoingSendingMethod>AuthCurrentUser</OutgoingSendingMethod>
|
Back to Top |
|
|
Igor AfterLogic Support
Joined: 24 June 2008 Location: United States
Online Status: Offline Posts: 6103
|
Posted: 02 June 2013 at 9:54pm | IP Logged
|
|
|
I understand you're using version 6 of WebMail Lite PHP, is that correct? If you enable logging in AdminPanel and reproduce the problem, what error message is recorded in the logs?
--
Regards,
Igor, AfterLogic Support
|
Back to Top |
|
|