Search The ForumSearch   RegisterRegister  LoginLogin

General Issues

 AfterLogic Forum : General Issues
Subject Topic: diff between System.net with mailbee.net Post ReplyPost New Topic
Author
Message << Prev Topic | Next Topic >>
ravikumarmp
Newbie
Newbie


Joined: 11 March 2010
Online Status: Offline
Posts: 13
Posted: 22 March 2010 at 4:32am | IP Logged Quote ravikumarmp

Hi,

I need the difference from System.net with Mailbee.net. I am wonder that we used to send bulk mails using System.net and our IP get blacklisted. If I use this mailbee.net can I get over this issue. Please let me know your suggestions.

Back to Top View ravikumarmp's Profile Search for other posts by ravikumarmp
 
Igor
AfterLogic Support
AfterLogic Support


Joined: 24 June 2008
Location: United States
Online Status: Offline
Posts: 6062
Posted: 22 March 2010 at 4:56am | IP Logged Quote Igor

I don't really think that switching from system.net to MailBee.Net would lower your chances to get blacklisted. Mail sending software does not offer any control on whether the sender is blocked by a recipient or by a third-party gateway.

--
Regards,
Igor, AfterLogic Support
Back to Top View Igor's Profile Search for other posts by Igor
 
ravikumarmp
Newbie
Newbie


Joined: 11 March 2010
Online Status: Offline
Posts: 13
Posted: 22 March 2010 at 9:37pm | IP Logged Quote ravikumarmp

ok thanks. I need to send 30,000 mails. can you give me the best way to send mails so that our IP should not blacklisted.

I know Time interval is the most important between mails. other than that is there any factor to set for sending mails.

how To validate the email id whether the id exits or not in the To field.
Back to Top View ravikumarmp's Profile Search for other posts by ravikumarmp
 
Igor
AfterLogic Support
AfterLogic Support


Joined: 24 June 2008
Location: United States
Online Status: Offline
Posts: 6062
Posted: 23 March 2010 at 2:24am | IP Logged Quote Igor

Like I said, there's no guaranteed way to ensure that you won't be blacklisted. Even small and fully legit mailings may sometimes be trapped by blacklists.

Quote:
how To validate the email id whether the id exits or not in the To field.


In MailBee.NET Objects, TestSend method can be used for this.

--
Regards,
Igor, AfterLogic Support
Back to Top View Igor's Profile Search for other posts by Igor
 

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

  Post ReplyPost New Topic
Printable version Printable version

Forum Jump

Powered by Web Wiz Forums version 7.9
Copyright ©2001-2004 Web Wiz Guide