MAILBEE POP3 SMTP WEBMAIL IMAP4 POP IMAP EMAIL COMPONENT VB ASP ACTIVEX COM VBA OCX NET .NET C# VB.NET ASP.NET DOWNLOAD QUEUE SSL SECURITY CENSOR ACCESS PARSER C++ DLL CONTROL LIBRARY MIME INTERFACE

MailBee POP3

AfterLogic Forum : MailBee POP3

Topic: [Error: Already connected]

Author

Message

<< Prev Topic | Next Topic >>

Guests
Guest Group

Joined: 10 November 2003
Online Status: Online
Posts: 262

Posted: 08 March 2005 at 7:46pm \| IP Logged

I get the error '[Error: Already connected]' when using this code copied from your FAQ, any suggestions ? Thanks.

Dim Mailer, Msg, Msgs
Set Mailer = CreateObject("MailBee.POP3")
Mailer.LicenseKey = "<my key>"
Mailer.Connect HOST, PORT, USERNAME, PASSWORD
If Mailer.Connect Then
   Set Msgs = Mailer.RetrieveHeaders
   Response.Write Msgs.Count & " messages total in mailbox<br>"
   For Each Msg In Msgs
      Response.Write "Subject: " & Msg.Subject & "<br>"
   Next
   Mailer.Disconnect
Else
   Response.Write Mailer.ErrDesc
End If         &nbs p;

Guests
Guest Group

Joined: 10 November 2003
Online Status: Online
Posts: 262

Posted: 08 March 2005 at 7:53pm \| IP Logged

Also it works if I remove the IF THEN check ...

           Dim Mailer, Msg, Msgs
           Set Mailer = CreateObject("MailBee.POP3")
           Mailer.LicenseKey = "MBC500-A4ACD4E493-E90B0116BB66090F8B4DC2360EC1027C" &n bsp;
           Mailer.Connect HOST, PORT, USERNAME, PASSWORD        &nbs p;
           'If Mailer.Connect Then
               Set Msgs = Mailer.RetrieveHeaders
              Response.Write "Total of " & Msgs.Count & " messages are avialable on the server.<br>"
              For Each Msg In Msgs
                  Response.Write "Subject: " & Msg.Subject & "<br>"
              Next
              Mailer.Disconnect
           'Else
           ' Response.Write Mailer.ErrDesc
           'End If         &nbs p;

Alex
AfterLogic Support

Joined: 19 November 2003
Online Status: Offline
Posts: 2207

Posted: 09 March 2005 at 7:45am \| IP Logged

In your code call to Connect method is made twice - this caused an error. If you open FAQ once again, you can see the following syntax is used:

Mailer.Connect ...
If Mailer.Connected Then
...

Connected is a property while Connect is a method.

Or, you can use one line instead of two:

If Mailer.Connect(...) Then

Anyway, only one call to Connect method is allowed.

Regards,
Alex

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

Printable version

Forum Jump

.NET Components

ActiveX Components

Web scripts

Solutions

MailBee POP3